The Shape After the Slot

The return pose first appeared after a brief pause beyond the wall. The animator had made a comfortable hand and the traveler used it to take the next step. The missing action was how that hand could form while the traveler rested on the ledge. We kept a narrow part of the grip in place and built the return around a change that could be read within one shot.
Choose the surface that can carry the pause
When the traveler leaves the slot, the left elbow reaches a low lip before the fingers do. The right arm is still narrow and pointed. We set the elbow down first, so the character already has something to rest on if the player pauses to inspect the destination. The first fingers can extend around the top of the ledge while the rest of the clay remains in its compressed pose.
The animation doesn’t need to make the whole hand appear at once. Use part of the forearm to widen the first finger joint while the end of the palm stays attached. The motion begins close to the part the player already touched. One frame leaves the original hand clear enough to read, and a later frame shows where the material crossed the elbow. The in-between pose is functional. It can support one part of the next movement before the full hand is available.
Retain a mark through the return
We found that a thumbprint was easier to follow than a thin edge during this change. The print starts near the joint and travels a little toward the palm. It does not rotate all the way out of view until the next shot. Combining the thumbprint with a shallow line in the paper ledge gives the viewer two kinds of evidence. One moves along the hand. The other makes its position against the set clear.
The first drawing had a smooth palm at the end of the pose. It looked like the animator had switched to another model. We added a subtle crease that survives the return and lets the hand take a new hold. The traveler can use that hand immediately even though the surface has not returned to its original shape. This reflects a specific choice about how far to finish the current action.
Leave one useful part narrow
A broad hand helps pull the traveler upward. It can be less useful when there is another narrow hole directly behind the ledge. The prototype provides a complete return and a shallower return that stops once there is enough clay for a hold. This second option can keep a bit of the thinner shape for the next corridor. The current setup lets the traveler test that partial hand beside the same ledge before climbing.
We maintain separate records of the two poses. A player can walk to the next opening and look at what the shallower return left available. The pose does not quietly reset after leaving the ledge. If the new opening is wide enough, the viewer can stretch the remaining part of the hand and continue. This makes the return its own action instead of a reward cutscene after the squeeze.
Review the material across both records
Pressure and Volume follows the starting shape and the first place it collects around the elbow. This return exercise begins with that pose already in contact with the far shelf. In the prototype’s return section the player can compare how much material reaches the palm on the two routes. The thumbprint should remain visible until they can explain the difference. That is the point where the model can change again without making the earlier move seem as though it happened off screen.